w3c

w3c

E3D RapidChange Revo™ Micro - 1.75mm, 24V Single Nozzle Kit

127,05 €

105,00 € HT

E3D RapidChange Revo™ Micro - 1.75mm, 24V Single Nozzle Kit

127,05 €

105,00 € HT

w3c

Quantité :

  Service local

Un service personnalisé en français

  Politique de livraison

Livraison rapide en Belgique et en France

  Technical support

Technical support and warranty directly from Slice3D

Titanium-like performance. Our special manufacturing process gives this aluminium HotEnd the strength and low thermal conductivity of titanium, without actually being titanium!

Ready for Revo. Change nozzles at room temperature using just your fingers. No complex tools, no hot tightening. Revo Nozzles are a factory sealed nozzle and heatbreak in one, so theyre easy to fit and cant leak material when in use.

New hotness. A Revo HeaterCore heats up in seconds. Its much safer too unlike other solutions on the market, a positive temperature coefficient (PTC) means the Revo HeaterCore can not melt at extreme temperatures: power reduces as it gets hotter, so hazards are reduced in the event of a thermal runaway.

Runs cool, looks cool. With an anodised black heatsink, not only does Revo Micro run cool it looks cool, too.

Flexible to any setup. Revo Micro plays nice with Bowden and direct drive setups, but its lightweight construction makes it an ideal choice for Bowden setups.

Please note:

  • This kit does not include any 3D printed mounts
  • The Revo Micro fan must be connected using the 5V regulator unless connecting directly to a 5V pin
  • This kit comes with 100mm of PTFE tube
  • You may need to adjust your Z offset when changing nozzles.

Boxed:

Sticky Add To Cart

Font: